|
THE HOT TUB/SPA IS CLEANED AND SERVICED ON EACH CHANGEOVER-DAY
- The chemicals used in the tub are activated by the water temperature and the thermostat is set for normal use.
It may take several hours for the tub to reach desired temperature after draining and cleaning. Water may appear
cloudy until chemicals have properly dispersed.
THE HOT TUB/SPA IS CHECKED AGAIN AT MID-WEEK
- If the tub is excessively dirty and a mid-week cleaning is required, there may be a service charge.
TEMPERATURE SETTING
- Water temperature should not exceed 104 degrees F. Lower water temperatures are recommended for
extended use (exceeding 10 - 15 minutes).
JET SETTINGS
- Blowers and high jet settings should not be used for more than 30 minutes. Excessive use can cause
overheating and permanent damage to the motor. Leave tub on low jets, and replace cover when not in use.
HOT TUB COVER
- Hot tub covers are fragile; please use care when removing and replacing. Please do not sit on hot tub cover as it may break!
The styrofoam inserts crack easily and are expensive to replace. If the cover is found damaged,
please contact our office immediately. Keeping the hot tub covered when
not in use will help keep the water warm.
SHOWER BEFORE ENTERING SPA
- Suntan lotions and sand (check bathing suit) can clog the plumbing, cause malfunction, upset the
spa water balance, and is difficult to get out of the tub.
PLEASE DO NOT OVER-CROWD THE TUB
- Too many people in the tub causes the water level to rise and overflow, resulting in motor damage.
SLIPPERY SURFACES
- Always enter and exit spa slowly. Surfaces may be wet and slippery.
FLOATERS
- It is important that all chemical floaters remain in the hot tub in order to maintain the chemical balance.
This helps keep the water clean and safe.
IF HOT TUB DOES NOT WORK
- First check the circuit breaker box. Turn the tub off, hit the reset button and wait for the covered
tub to reheat (6-8 hours). If the Hot Tub won't heat, or jets won't start, you may need to reset the
High Limit Switch, usually located on a gray disconnect box near the tub. There may be a GFI reset switch
in the same area. If so, reset it also. Wait for the tub to cool before resetting. If resetting is required
more than 2 times in a half hour, please call the office for service (261-3934 ext. 234).
DO NOT continue to reset more than 2 times!
|